11-29-10
1. Fixed application installation/setup. The original setup process was 
failing on some systems so we replaced it with the archive that contains
all the files that were being copied to various places on the system. That
allows the application to be run on a system without modifying any existing
files that may already be on the system.


9-7-10
1. Changed IsEMF=1 to IsEMF=0, making the labeling default to zero-based.
For example, with zero-based labeling, the first channel would show as 0.




10-11-05

1. Fixed problem with rate change in application.




10-7-05

1. Removed dialog box for entering an experiment name at start of the scan
2. Modified handling of rate save to .ini file when a rate change is made.
3. Removed writing of experiment name and subcycle averaged entries to log file





12-21-04

1. Fixed Max/Min graph range so that it will correct for incorrect
numeric values. Although this worked for the most part already, it
would still fail on a floating point value if two decimal points
were entered - as an example.

2. Changed graphing line resolution to one pixel from two pixels.

3. Removed disabling of the "Un/Select" graphing channels durning the
actual scan process. This was only enabled while not scanning.



1-16-05
Fixed failure to save "AutoScale" when it was automatically changed
by changing one of the Fullscale (pos and neg) values

Fixed drawing of dots.

Fixed drawing of graph which had problems when the "sec/screen" was
set very high.